Connecting Additional Hardware; Information On The Balance; Keyboard - Buttons Function - RADWAG R Série Mode D'emploi

3.7. CONNECTING ADDITIONAL HARDWARE

Use only accessories and peripheral equipment recommended by the manufacturer. The balance
must be disconnected from the mains before connecting or disconnecting any peripherals (printer,
PC computer, computer keyboard). On connecting the peripherals, plug the balance to the mains.

3.8. INFORMATION ON THE BALANCE

<INFO> menu provides information on the balance: balance type, software version, internal
temperature of the balance. The parameters are strictly informative.
<SETUP PRNT.> parameter has been designed to enable sending balance settings to printer (all
parameters).
4. KEYBOARD – BUTTONS FUNCTION
Press to switch the balance ON/OFF. If switched off, balance
components other than the display are powered, and balance is in
stand-by mode.
F9 button of the computer keyboard.
Press to access data stored in a database: user, product, tare.
F10 button of the computer keyboard.
Press to enter directly the active working mode settings.
F11 button of the computer keyboard.
Press to select working mode.
F5 button of the computer keyboard.
Press to change measuring units.
PRINT/ENTER button
Press to send measurement to a printer or a computer (PRINT).
Press to confirm selected parameter value or function (ENTER).
Press to Zero the balance
Press to Tare the balance
Press to start adjustment / calibration process immediately.
F6 button of the computer keyboard.
Press to enter the main menu of a balance.
F7 button of the computer keyboard.
Press to operate balance menu or change parameter value.
- 15 -