EUROM PAC 12.2 Mode D'emploi page 17

OPERATION
The control panel and remote control have the same buttons. This means that they give the
same commands. The control panel also has lights that indicate the mode set. The control
panel also has a W.F. light (water tank full) and a display that shows the temperature and timer
settings.
Before using the air conditioner, check:
 That it has been installed according to safety instructions
 That it is not damaged or broken
 That the electrical socket that you wish to use has the same voltage as is given on the unit's
specification plate (220-240V / 50Hz)
 That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket. Start the unit by pressing on
the POWER button.
Use the MODE button to choose a specific function: automatic function, cooling, dehumidifying
or ventilate. Every time you press the button, the function changes. The light on the control
panel shows which function is active. If you are cooling or dehumidifying, wait for up to 3
minutes after switching on or off before switching the unit on or off again. The compressor
needs this time to recover.
Automatic cooling:

Press MODE until the AUTO indicator lights up.
The device will, depending on the ambient temperature, automatically select a desired
temperature with the accompanying function: cool, dehumidification or ventilation. This indicator
light will also activate.
Ambient temperature
Mode
Desired temperature
Cooling:

Press MODE until the COOL indicator lights up.

Press TEMP+ / TEMP- (Λ / V) to set the required temperature (from 16°C to 31°C)

Press SPEED to select desired fan speed (low, medium or high).
Dehumidifying:

Check that the water outlet hose is correctly connected, see page 6!

Press MODE until the DEHUM indicator lights up.

The temperature will be automatically set to 2 degrees below room temperature (16°C to
31°C).
The fan speed will be automatically set to 'LOW'.

Ventilation:

Press MODE until the FAN light is lit
23°C ≤ amb. temp ≤ 26°C.
< 23°C
Ventilation (fan) Dehumidification (dehum)
21°C
17
23°C
≥ 26°C
Cooling (cool)
25°C