Cleaning And Disinfecting; Maintenance Work - Dräger X-plore 8000 Notice D'utilisation

4 Maintenance
4.1

Cleaning and disinfecting

CAUTION
!
Potential damage to components!
Only use the prescribed processes and the cleaning and
disinfection agents specified for cleaning and disinfecting.
Other agents, methods, dosages and contact times may
damage the components.
Health hazard!
The undiluted agents are damaging to health if they come into
direct contact with the eyes or skin. Wear safety goggles and
protective gloves when working with these agents.
1. Clean all parts with lukewarm water and Sekusept
a soft cloth (max. temperature: 30 °C; concentration depending on
the degree of contamination: 0.5 - 1 %)
does not get scratched.
2. Rinse all parts thoroughly under running water.
3. If the sweatband needs disinfecting:
a. Prepare a disinfectant bath of water and Incidin
temperature: 30 °C; concentration: 1.5 %)
b. Put the sweatband into the disinfectant bath (duration:
15 minutes).
c. Rinse the sweatband thoroughly under running water.
Allow all parts to air-dry or or dry them in the drying cabinet

(temperature: 60 °C). Keep away from direct sunlight.
®
1) Sekusept is a registered trademark of Ecolab Deutschland GmbH
®
2) Incidin is a registered trademark of Ecolab USA Inc.
Dräger X-plore 8000 Helmet with Visor
4.2
4.2.1
1. Check the helmet shell, interior, visor and accessories for cracks,
2. Replace scratched or damaged parts.
®
Cleaner with
1)
. Make sure the visor
4.2.2
1. Release the Velcro fasteners on the face cuff from the support
®
Rapid (max.
2) 2. Remove the visor from the adapters and pull the face cuff from the
.
3. Position the face cuff bottom centre on the visor. Ensure that the
4. Insert the visor bracket through the loops in the face cuff and place
5. Insert the visor bracket as far into the adapters on the helmet as

Maintenance work

Checking usability
deformations or other damage, as well as wear. Check also that
the helmet fits correctly.
CAUTION
!
The protective effect is reduced after impact!
If the helmet absorbs the energy of an impact, it can get
damaged or destroyed.
Even if the damage is not visible at first, the helmet must be
replaced after a heavy bump or impact. Damaged or impact-
stressed helmets must no longer be used. This also applies if
no external damage is visible.
Reduced visibility or limited protective effect by scratched or
damaged visors!
Replace scratched or damaged visors.
Replacing the face cuff
ring.
visor.
tabs are on the outside.
Fully attach the Velcro fastener to the visor.
the loops around the joints on the visor bracket.
possible.
Maintenance
19