White Balance Setting [White Bal] - Panasonic WV-CLR930 Mode D'emploi

7. White balance setting [WHITE BAL]

The white balance adjustment is selectable from the following.
ATW1 (default): Activates the automatic color temperature tracking mode. The camera contin-
uously measures the color temperature of the light source and automatically adjusts the
white balance. Manual fine adjustment is also enabled after automatic white balance set-
ting. ( page 39)
The adjustment of the color temperature ranges from approx. 2 700 K to 6 000 K. If the sit-
uation meets one of the following or other, color may not be accurately reproduced.
• The subject is mostly highly-colored.
• The photographic atmosphere is under the bright blue sky or at nightfall.
• The illumination of the light illuminating the subject is low.
ATW2: Activates the sodium lamp automatic color temperature tracking mode. The camera
automatically achieves an optimal white balance under the sodium lamp.
The adjustment of the color temperature ranges from approx. 2 000 K to 6 000 K.
AWC: Activates the automatic white balance control mode. This adjustment is suitable for a
location where a light source is stable. The adjustment of the color temperature ranges
from approx. 2 000 K to 10 000 K. When "AWC" is selected, the operation to adjust the
white balance is required.
When "AWC" is selected, follow the steps below to adjust the white balance.
"CAMERA SETUP" screen
**CAMERA SETUP** 1/2
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
DNR
RESOLUTION
BW MODE
Step 1
Set "WHITE BAL" to "AWC" and press the left
button to change to "AWC → PUSH SW".
Step 2
Press the setting button and adjust the white
balance.
"PUSH SW" is reversely highlighted during
adjustment. When the reversely highlighted
display is restored, the white balance adjust-
ment is completed.
38
O
OFF
ALC O
OFF
O
ON
OFF
INT
O
AWC
OFF
HIGH
HIGH
O
Step 3
Press the right button to select "AWC".
Refer to the next page for fine adjustment of
the white balance.
Note:
• The adjustment of the color temperature
ranges from approx. 2 000 K to 10 000 K.
If the correct range is out of this adjust-
ment range or lighting directed to a sub-
ject is too dark, the white balance may
not completely adjusted. In such a case,
"PUSH SW" stays reversely highlighted.