Kenwood FDM31 Instructions page 10

4 Add the ingredients.
5 Fit the lid - ensuring the end of the shaft
locates into the centre of the lid.
Hints and Tips
Important
The whisk is not suitable for making all
in one cake mixes as these mixes are too
heavy and will damage it. Always use the
knife blade.
Best results are obtained when the eggs are
at room temperature.
Ensure the bowl and whisks are clean and
free from grease before whisking.
Discs
18 20
–
To Use The Cutting Discs
1 Fit the drive shaft and bowl onto the power
unit.
2 Holding by the centre grip, place the disc
onto the drive shaft with the appropriate side
uppermost.
3 Fit the lid.
4 Put the food in the feed tube.
5 Switch on and push down evenly with the
pusher - never put your fingers in the feed
tube.
Hints and Tips
Use fresh ingredients
Do not cut food too small. Fill the width of
the feed tube fairly full.This prevents the food
from slipping sideways during processing.
When slicing or grating: food placed
upright comes out shorter than food placed
horizontally.
There will always be a small amount of waste
on the disc or in the bowl after processing.
Citrus Juicer
21
Cone
Sieve
To use the citrus juicer
1 Fit the drive shaft and bowl onto the power
unit.
2 Fit the sieve into the bowl - ensuring the
sieve handle is locked into position directly
over the bowl handle.
3 Place the cone over the drive shaft turning
until it drops all the way down.
4 Cut the fruit in half. Then switch on and press
the fruit onto the cone.
The citrus juicer will not operate if the sieve
is not locked correctly.
(if supplied)
Hints and Tips
For best results store and juice the fruit
at room temperature and hand roll on a
worktop before juicing.
To help with juice extraction move the fruit
from side to side when juicing.
When juicing large quantities, empty the
sieve regularly to prevent the build up of
pulp and seeds.
Mini Chopper/Mill
22
Jar
Sealing ring
Blade assembly
1 Put the ingredients into the jar.
2 Fit the sealing ring into the blade assembly.
3 Turn the blade assembly upside down. Lower
it into the jar, blades down.
4 Screw the blade assembly onto the jar until
finger tight. Refer to the graphics on the
underside of the blade assembly as follows:
- Unlocked position
- Locked position
5 Place the mill onto the power unit, align the
on the mill with the
and turn clockwise to lock
6 Select Maximum speed or use the pulse (P).
Hints and Tips
Baby food/purée - allow cooked food to
cool down to room temperature before
processing in the mill.
For best results the main bowl is
recommended when chopping herbs.
Grinding Mill
23
Mill lid
Grinding mill blade assembly
1 Place your ingredients into the blade
assembly.
2 Fit the lid and turn clockwise to lock.
3 Place the mill onto the power unit and turn
clockwise to lock.
4 Select maximum speed or use the pulse (P).
7
(if supplied)
on the power unit
.
(if supplied)