Inglesina APTICA Manuel D'instructions page 34

HINTS FOR CLEANING THE TEXTILE LINING
• It is recommended to wash the lining separately from
other items.
• Periodically revive the fabric parts using a soft clothes
brush.
• Follow the lining washing instructions on the labels.
Handwash in cold water
Do not bleach
Do not tumble dry
Dry flat in shade
Do not iron
Do not dry clean
Do not spin-dry
LIST OF COMPONENTS
fig. 1
APTICA STANDARD CHASSIS
A Rear wheels
B Rear axle
C Front RH wheel assembly / Front LH wheel assembly
APTICA XT CHASSIS
D Rear wheels
E Front RH wheel assembly / Front LH wheel assembly
APTICA CARRYCOT
F Hood lining
G Carrycot apron
STROLLER
H Stroller seat
I Handrail
J Hood
ACCESSORIES
K Feeding bottle holder
L Storage basket
M Muff (if available)
N Rain cover (if available)
INFANT CAR SEAT (if available)
APTICA STANDUP (if available)
CHASSIS
OPENING THE CHASSIS STRUCTURE
fig. 2 Holding the lever (O) down, lift the chassis firmly
until it opens completely.
fig. 3 Caution: make sure that all closing mechanisms
are properly attached on both sides before use.
STANDARD VERSION
ASSEMBLING/REMOVING THE REAR WHEELS
fig. 4 Insert the rear axle (B) in both of the rear tubes (B1)
34
• Dry the textile lining completely before using or storing it.
• To prevent formation of mildew, it is advisable to air the
carrycot periodically. In particular, separate the textile lining
from the structure and run a dry cloth over the bottom.
INSTRUCTIONS
of the chassis and push it into its housing.
fig. 5
correctly, making sure that both the pins (B2) are in their
housings.
fig. 6
push it into its housing until it clicks correctly into place.
Proceed in the same way for the other wheel.
fig. 7
attached before use.
Should it be necessary, the rear wheels and rear axle can
easily be removed.
fig. 8
(A).
fig. 9
from the chassis tube.
ASSEMBLING/REMOVING THE REAR WHEELS
fig. 10
push it into its housing until it clicks correctly into place.
Proceed in the same way for the other wheel.
fig. 11
attached before use.
Should it be necessary, the rear wheels can easily be removed.
fig. 12
(D).
ASSEMBLING/REMOVING THE FRONT WHEEL ASSEMBLY
fig. 13
for the XT version are divided into RH (right) and LH (left)
and can be easily identified by the reference (W1) stamped
at the fastening peg. The same reference (W2) is also printed
on both front chassis supports.
fig. 14
corresponding front chassis support, until it clicks correctly
into place.
fig. 15
kept on the outside helps to identify correct RH and LH
correspondence between wheels and chassis more easily.
fig. 16
Caution! Ensure that the rear axle (B) is attached
Insert the rear wheel (A) on the rear axle (B) and
Caution: make sure that the wheels are properly
Operate the lever (A1) and detach the rear wheel
Holding down the pin (B2), remove the rear axle (B)
XT VERSION
Insert the rear wheel (D) on the rear axle (B) and
Caution: make sure that the wheels are properly
Operate the lever (D1) and detach the rear wheel
STANDARD VERSION & XT VERSION
The front wheel sets for both the STD version and
Insert the front wheel assembly (C/E) in the
The hole (W3) on the wheel assembly and always
Caution: make sure that the wheels are properly