To Access The Basic Settings; Suitability Test Of Cookware - Gaggenau CI 292 600 Notice D'utilisation

To access the basic settings:

The cooktop must be switched off.
1 Switch on the cooktop.
t
2 Touch the symbol within the next 10 seconds.
The first four displays provide product information.
Turn the twist knob to view the individual displays.
Product information
Customer service index (CSI)
FD number
FD number 1
FD number 2
t
3 Touch the symbol again to access the basic
settings.
™‚ ‹¯
and light up as a presetting in the displays.
t
4 Touch the symbol repeatedly until the required
function is displayed.
5 Then use the twist knob to select the required
setting.
t
6 Touch the symbol for at least 4 seconds.
The settings have been saved.
Leaving the basic settings
Turn off the cooktop with the main switch.

Suitability test of cookware

This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the element being used.
Display screen
1
‹‚
"š
Š†
.
‹ †
.
2
3
After 10 seconds, the result for the quality and speed of
the cooking process will appear on the element display.
Check the result using the table below:
Result
‹
‚
ƒ
* If there is a smaller element available, try the cookware again
To reactivate this function, touch the settings range.
Notes
‒
‒
‒
With the cookware still cold, fill it with approx.
200 ml of water and place it on the center of the
element with the diameter that most closely
matches that of the base of the cookware.
Go to the basic settings and select the
Touch the settings range.
element display.
The function has now been activated.
The cookware is not suitable for the element and will
therefore not heat up.*
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it ought
to.*
The cookware is heating up correctly and cooking is
progressing well.
on the smaller element.
If the diameter of the element used is much smaller
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information about this function in
section ~ "Basic settings"
You can find information about the type, size and
positioning of the cookware in the section on
™ˆ
setting.
A
will flash on the
39