Turning Off The Machine - Astoria Plus4You TS Manuel D'utilisation Et D'entretien

When the machine turns on, it performs a functional
test and reports information regarding the installed
software.
XX.XX.XXXX: update date
RY: revision number
FUNCTIONAL TEST
EVPRO XX/XX/XXXX RX
O.K. indicates that the machine is working correctly.
If there is a negative result, check the warning on the
display;
When the machine is turned on, the motor pump is
activated which starts to fill the steam heating unit
and the water heaters for the coffee (there are the
same amount of these as there are dispensing groups
in the machine);
COFFEE
FILLING UP WATER
In order to remove the air from the heaters, each
time the machine is turned on, the group solenoid
valves are activated, making water and steam come
out of the shower screen of each group for around
10 seconds;
BE CAREFUL
WATER/STEAM MAY ESCAPE
When the heating phase of the dispensing groups
has finished (after about 10 minutes), signalled by
the "PLEASE WAIT" warning disappearing, it will be
possible to make coffee selections. The steam heating
unit needs to fully heat up before hot water or steam
can be dispensed;
Heating up.
Please wait...
During the heating phase of the steam heating unit
(from 95°C to 98°C), the machine will dispense a small
amount of water and steam from the water spout;
USER manual
TEST
-OK-
Steam and water can only be dispensed, i.e. the ma-
chine can only be fully functional, if the pressure of
the machine ( ) is higher than 0.6 bar.
During the machine's heating-up phase (roughly 20 minutes), the
negative pressure valve will release steam for a few seconds until
the valve closes.
The temperature instead of the pressure will be shown on the
display in °C, until it reaches 100°C.
Then the value will be converted into bars (pressure).

7.3.2 Turning off the machine

Turn off the machine via the main switch (4).
55 260
of