Ryobi RBC430SESC Manuel D'utilisation page 25

ATTACHING THE GRASS DEFLECTOR
See Figure 5.
Attach the blade guard to the mounting bracket and
align the screw holes on the blade guard to the
screws on the mounting bracket.
Using the combination wrench, tighten all two screws
securely.
NOTE: When using the string head, the grass deflector
must be attached to the blade guard.
Attach the grass deflector to the blade guard and
align the 3 screws on the grass deflector to the screw
holes on the blade guard.
Using the combination wrench supplied, tighten all 3
screws securely.
WARNING
Always stop the engine and remove the spark
plug wire before making any adjustments such
as changing cutting heads; this is to reduce the
risk of serious personal injury.
INSTALLING ReelEasy TM
See Figure 6.
Open the ReelEasy
depressing the latches on each side. The contents of
the line trimmer head are spring loaded, so keep your
other hand over the line trimmer head cover while
depressing the latches.
Remove the line trimmer head cover, knob and spool
then set aside.
Place the line trimmer head on the drive shaft. Make
sure the line trimmer head is fully seated.
Install the hex bolt into the opening on the drive shaft
and secure using the hexshaped opening in the knob
to tighten.
NOTE: Only use the knob to tighten the bolt. The use of
other tools may allow over tightening of the bolt, which
could damage the line trimmer head.
Install the spring into the line trimmer head and push
down to seat.
Installing the spool. For the RLT430SES straight line
trimmer attachment, the spool should be placed so
"this side out for straight shaft" is visible. If you are
using a curved shaft attachment with the Real easy
cutting head the spool should be placed "the side out
for curved shaft" is visible.
Replace the knob in the spool.
Replace the line trimmer head cover, aligning latches
with openings in the line trimmer head. Press cover
and line trimmer head together until both latches snap
into openings securely.
Install line as described in the next section of this
English(Original instructions)
STRING HEAD
TM line trimmer head by
manual.
ATTACHING THE SHOULDER STRAP
Note: Always use the shoulder strap/harness with your
brushcutter.
RBC430SESC
Follow these steps to attach the shoulder strap.
Note: To quickly release the product from the shoulder
strap, sharply pull the quick release tab.
RBC430SBSC
See figure 4.
Follow these steps to attach the shoulder strap.
strap hanger.
KNOW YOUR BRUSHCUTTER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarise yourself with all
operating features and safety rules.
GRASS DEFLECTOR
The brushcutter includes a grass deflector that helps
protect you from flying debris.
SHOULDER STRAP
The brushcutter includes a shoulder strap that helps
support the product.
TOP-MOUNTED MOTOR
The top-mounted motor improves balance and is located
away from the dust and debris of the cutting area.
OPERATION
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses
with side shields when operating power tools.
Failure to do so could result in objects being
thrown into your eyes resulting in possible
serious injury.
23