Honda EU65is Mode D'emploi page 432

cap.16 EU65is 6500is 07.12.17 5:07 PM ページ16-4
3. HANGER
a. DISASSEMBLY/REASSEMBLY
HANGER INSTALLATION/REMOVAL
Protect the tank and frame pipe with the protector films during
installation/removal of the hanger.
1) Insert the bracket installation part at one end of the hanger
into the clearance between the frame pipe and fuel tank.
2) Slide the hanger and insert another bracket installation part
of the hanger into the gap between the frame pipe and fuel
tank on the other side.
3) Slide the hanger along the frame pipe to the hanger
installation position. Install the hanger brackets on both
ends of the hanger and tighten the 8 mm flange bolts
securely.
Removal is the reverse order of installation.
16-4
[1]
HANGER
[1]
PROTECTOR FILMS
[2]
Align the center of the hanger
with the recessed part on the rear
side of the fuel tank.
8 x 20 (4)
[2]
HANGER BRACKET (2)