Honda EU65is Mode D'emploi page 360

cap.11 EU65is 6500is 07.12.17 5:03 PM ページ11-3
3. COOLING FAN/IGNITION PULSE GENERATOR
a. DISASSEMBLY/REASSEMBLY
[1]
10 x 25
DISASSEMBLY/REASSEMBLY:
• Remove the ignition pulse generator,
and hold the rotor with a commercially
available strap wrench and loosen or
tighten the flange bolt.
• Take care not to damage the fan.
[1]-1
STRAP WRENCH
(Commercially
available)
[9]
10 mm WASHER
[8]
STARTER PULLEY
11-3
[2]
5 x 14 mm SOCKET BOLT (2)
6 N . m (0.6 kgf . m, 4.4 lbf . ft)
[10]
HARNESS CLIP
[6]
RECOIL PULLEY
ADAPTER
[7]
6 x 25 (4)
REASSEMBLY:
Tighten the 6 x 25 mm flange bolts
in a crisscross pattern in two or
three steps.
[3]
IGNITION PULSE GENERATOR
INSTALLATION: P. 11-4
INSPECTION: P. 11-4
[4]
IGNITION PULSE
GENERATOR
BRACKET
6 x 25 (2)
[5]
COOLING FAN
REASSEMBLY:
Install the cooling fan by aligning the
four lugs with the holes of the rotor.
[5]-1 LUG
[5]-2 HOLE