System Programming - Honeywell 301C Manuel De L'utilisateur

System Programming

The system's Normal programming mode offers several menu options
that are accessible from the main menu screen:
1. Tx Info:
2. Groups:
3. Events:
4. Acqui:
5. Copy:
6. Config:
7. Network:
8. Tests:
9. BACNet:
10. Wireless:
Note: Access to the programming functions is password protected.
The default password is 2967.
The screen display shown below appears initially. This display can be
configured to scroll among the information screens for each device
connected to the controller.
If one or more of the connected devices is in an alarm mode, the
controller will only scroll between the main information screen and the
screens for device(s) in alarm mode. In this case, you must scroll
manually to view screens for other devices.
Allows transmitter parameters to be programmed
Allows sets of multiple transmitters to be aggregated
for simpler programming of a common response.
Facilitates creation of logical terms which respond to
transmitters or events. These Boolean outputs can
respond to concentration, alarm, or fault status. These
events facilitate voting within a group and can drive
relay outputs.
Allows the datalogging feature to be activated or
deactivated
Allows data or parameters to be copied from the
(controller) configuration to parameters
Allows system parameters and password to be set
Allows actions on the network to be performed,
communication statistics to be consulted, and remote
calibrations to be performed
Allows each device to be tested sequentially (inputs,
outputs, communications, events, etc.) and operation
of various parameters to be validated
Allows a device's BACNet parameters to be set
Not supported.
20