Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
3
The condenser has sharp edges.
The condenser has sharp edges.
goggles and face masks.
goggles and face masks.
Do not use direct water jets to clean the appliance.
Do not use direct water jets to clean the appliance.
8.2.5 – CLEANING THE CORE PROBE
Carry out this operation at every cycle.
APPLIANCE STATUS:
-
ON/OFF button in position "O" (OFF);
AUTHORIZED PERSONNEL
Appliance operator.
METHOD
The core probe (ref. 1 fig. 10) must always be cleaned before a new cycle so as to avoid polluting the product in any way.
The core probe (ref. 1 fig. 10) must always be cleaned before a new cycle so as to avoid polluting the product in any way.
The core probe (ref. 1 fig. 10) must always be cleaned before a new cycle so as to avoid polluting the product in any way. Remove all
residue by means of a sponge soaked in neutral detergent. Rinse with lots of water and apply a sterilising product.
residue by means of a sponge soaked in neutral det
1
BCB_03-05-10-15 Rev.02
position "O" (OFF);
ergent. Rinse with lots of water and apply a sterilising product.
When carrying out the operations mentioned above, wear safety gloves,
When carrying
out the operations mentioned above, wear safety gloves,
1
pag. 67
Fig. 9
Fig. 10
Publicité
Table des Matières
