Safety Equipment; Cleaning, Maintenance And Ordering Spare Parts; Ordering Replacement Parts; Disposal And Recycling - EINHELL BT-GW 190 D Mode D'emploi

Anleitung_BT_GW_190_D_SPK1:_
GB
Hold the welding screen (Fig. 3/17) in front of your
face and move the gas nozzle to the point on the
workpiece where you wish to complete the weld.
Now press the burner switch (Fig. 5/25).
When the arc is burning, the welding set will feed
wire into the weld pool. When the weld nugget is
large enough, move the burner slowly along the
required edge. Move it to and fro if necessary to
enlarge the weld pool a little.
Find the ideal setting of the welding current, wire
feed speed and gas delivery rate by carrying out a
test weld. Ideally an even welding noise will be
audible. The penetration depth should be as deep as
possible, but the weld pool must not be allowed to
fall through the workpiece.

6.4 Safety equipment

6.4.1 Thermostat
The welding set is fitted with an overheating guard
that protects the welding transformer from
overheating. If the overheating guard trips, the
control lamp (3) on your set will be lit. Allow the
welding set to cool for a time.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
22
16.12.2008 17:07 Uhr Seite 22

7.3 Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.