Table Des Matières; Introduction - Thermador Professional PCG 30 Manuel D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour Professional PCG 30:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INTRODUCTION

IMPORTANT
All Cooktops having less than 12" (305 mm)
horizontal clearance between combustible ma-
terials and the back edge of the Cooktop must
be installed with a Thermador Low Back Back-
guard. If more than 12" (305 mm) horizontal
clearance exists, a Thermador Island Trim may
be used instead of the backguard. Before using
the Cooktop, insure that it is equipped with the
appropriate Low Back Backguard or Island Trim.
Refer to the Installation Instructions accompa-
nying this appliance for more information.
Cooktops are shipped by the factory to operate on
natural gas. Verify that the type of gas being used at
the installation site matches the type of gas used by
the appliance.
If the location/job site requires a conversion from
one type of gas to another, contact the dealer where
the unit was purchased or contact Thermador. The
field conversion kit for this series of Professional
cooktops is Thermador Model PALPKITHC. Field
conversion must be done by qualified service
personnel only.
CAUTION
When connecting the unit to propane gas, make
certain the propane gas tank is equipped with
its own high-pressure regulator in addition to
the pressure regulator supplied with the range.
The pressure of the gas supplied to the appli-
ance regulator must not exceed 14" (34.9 milli-
bars) water column.
Table of Contents
Introduction ..................................................................1
Gas Type Verification ..................................................1
Safety Precautions ................................................... 3 - 4
SECTION THREE: Description
Model & Parts Identification - PCG 48 .....................6
Model & Parts Identification - PCG 36 .....................6
Model & Parts Identification - PCG 30 .....................6
Sealed Burners ............................................................7
Burners ......................................................8
®
Electronic Igniter ..........................................................9
Burner Cap Placement ................................................9
Flame Setting Guidelines ......................................... 10
Cookware Recommendations .................................. 11
Specialty Cookware .................................................. 12
Using the Griddle .............................................. 15 - 16
Griddle Cooking Recommendations ....................... 16
Cooktop Cleaning Recommendations ................. 17 - 19
Do-It-Yourself Maintenance ..................................... 20
Before Calling For Service ....................................... 21
Data Rating Plate ...................................................... 21
Warranty ...............................................................22-23
TESTED IN ACCORDANCE WITH ANSI
Z21.1, The STANDARD FOR HOUSEHOLD
COOKING GAS APPLIANCES. IN CANADA
TESTED IN ACCORDANCE WITH CAN/
CGA 1.1 - M81, STANDARD for DOMESTIC
GAS RANGES.
Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code No. Z223.1 /
NFPA 54 current issue and the National
Electrical Code ANSI/NFPA No. 70 current issue
or the Can - B149 Installation Codes for Gas
Burning Appliances and C22.1 Canadian
Electrical Code Part 1.
It is the responsibility of the owner and the
installer to determine if additional requirements
apply in specific installations.
1

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Professional pcg 36Professional pcg 48

Table des Matières