Section Six: Before Calling For Service; Do-It-Yourself Maintenance - Thermador Professional PCG 30 Manuel D'utilisation Et D'entretien

Section 6: BEFORE CALLING FOR SERVICE
POWER FAILURE
• In the event of a power failure, only the standard
burners can be lighted manually. It is necessary
to light each standard burner individually.
• If the cooktop is being used when the power
failure occurs turn all of the burner control knobs
to the OFF position. The standard burners can be
lighted by holding a match at the ports and turning
the control knob to the
flame is burning all the way around the burner cap
before adjusting the flame to the desired height.
The two ExtraLow® burners on the left side
cannot be used during a power failure. Be sure to
turn them OFF if a power failure occurs because
they will not turn back on until the control knobs
are turned OFF and then turned back on again.
See "What to do if you Smell Gas", inside front
cover.
• If you have low gas pressure, contact your gas
company.
SYMPTOM
Intermittent sparking
More than four clicks of
igniter before lighting
Constant Sparking

Do-It-Yourself Maintenance

position. Wait until the
• Ceramic igniter is wet or dirty.
• Burner ports are clogged.
• Improper fit of burner cap onto
burner base.
• Cooktop is not properly
grounded.
• Electrical power supply is
incorrectly polarized.
Intermittent or Constant Igniter Sparking
• Intermittent or constant sparking of the gas
surface burners can result from a number of
preventable conditions. Eliminate these
conditions as indicated in the chart.
CAUSE
20
REMEDY
• Carefully dry or clean igniter.
• Clean ports on burner cap
with a wire, a needle or
straightened paper clip.
• Align burner cap properly on
burner base.
• Refer to Installation
Instructions. Have a qualified
electrician ground
cooktop properly.
• Refer to Installation
Instructions. Have a qualified
electrician ground
cooktop properly.
the
the