Ts20 Probe - Renishaw TS20 Guide D'installation Et D'utilisation

TS20 with automatic arm
The TS20 is a two axis tool setting probe, used on
CNC lathes.
During a tool setting routine, each turret mounted
tool is driven against the square tip stylus. When
contact is made, a trigger signal is generated and
tool offsets are automatically recorded in the
machine control registers.
There are three versions of the TS20 probe,
for 24 mm, 32 mm or 40 mm tooling respectively.

TS20 PROBE

Stylus
TS20
Automatic arm
TS20 with high precision arm (HPA)
The probe may be mounted on an automatic
arm which is retracted out of the machines
working envelope when the probe is not in use.
Alternatively the probe may be mounted on a
Renishaw high precision manual arm (HPA).
A quick release mounting enables the HPA to
be easily removed from the machine when the
probe is not required.
During installation the probe stylus tip may be
set to align with the machine X or Y axes.
HPA
TS20
1-1