Engineering Units - Burkert 8175 Manuel Utilisateur

4.4.1 Language
The selection of an alternative language is confirmed by the Enter-key and becomes imme-
diately active.
LANGUAGE
UNIT

4.4.2 Engineering Units

The selection of the units will depend on the application and the configuration of the trans-
mitter via level, distance or volume for fluid measurement.
If the transmitter is to be configured to measure Level or Distance, select the measuring
-
units and decimal points as required.
If volume is to be selected and configured it is important to note that the transmitter
-
display within the 'VOLUME TEACH-IN' may not be the measuring units selected.
The conversion of units by the transmitter only applies within the Volume Teach-In and
the table below displays the measuring units selected and the displayed units which will
be used within the Volume Teach-In.
Selected measuring units
Distance
cm
m
cm
m
cm
m
inch
foot
inch
foot
inch
foot
8175
CALIBRATION MENU
ENTER
0......9
ENTER
Volume
L
L
m 3
m 3
US/Imp Gal
US/Imp Gal
L
L
m 3
3
m
US/Imp Gal
US/Imp Gal
29
ENGLISH
DEUTSCH
FRANCAIS
ITALIANO
ESPANOL
Units used for Teach-In
Distance
m
m
m
m
Not to be used
Not to be used
Not to be used
Not to be used
ft
ft
ft
ft
Volume
L
L
m 3
m 3
m 3
3
m
US/Imp Gal
US/Imp Gal