8175 Wall Mounted Version 115/230 Vac - Burkert 8175 Manuel Utilisateur

3.4.5 8175 Wall Mounted Version 115/230 VAC

Connection of the 8170 sensor
Open the cover after having unfasten the 4 screws on the front display.
-
Replace one of the housing cable glands through the cable gland inserted on the sensor
-
cable.
Connect the coax and PT1000 cables as shown in the diagram below.
-
Wires: Pink - Blue - Red - Black
SW 2,
Position A
Wires:
Brown
White
Yellow
Green
8175 wall mounted version 115/230 VAC with or without relays; Wiring
Remove the cover via the screws on the front display and pull the cable through the cable
gland then wire according to the pin assignment diagram below.
To connect the transmitter to a PLC, use terminals 10 and 12 and set SW2 to position A
(see figure above).
Terminals 13 to 16 must only be connected if the transmitter is a version with relays.
PLC, valve or positioner
INSTALLATION
+ -
Cable gland to remove
Cables with diameters between 4 and 8 mm.
Relay 1
I L+ L-
1 2 3 4 5 6 7 8 9 10 11 12
+
-
4-20 mA
20
250-mAT-fuse
Relay 2
R1 R1 R2 R2 115/230 VAC
13 14 15 16
L N
For security reasons, secure the
cables onto the board using the
cable clips provided.
115/230 VAC Po-
wer Supply switch
Power Supply
8175