Filter Function - Burkert 8175 Manuel Utilisateur

4.4.3 Filter Function

The function makes it possible to:
- activate the echo filtering and choose a damping level as well as a max. speed change
(FILTER 0 to 9)
- define the delay after which a failure is indicated by the outputs (DELA)
- select the type of tank (OPEN TAN, CLOSED or DOME(+)).
FILTER
GAS COMP
4.4.3.1 Filter 0 to 9
Echo Filtering:
Filters 0, 1 and 2: No echo filtering activated; The transmitter takes the nearest echo as the
level.
Filters 3 to 9: Echo filtering activated; The transmitter compares the echoes received with
those calculated within the ECHO menu so it can display the right level.
If no echo filtering is chosen, it is advised to select filter 0 during the Teach-In
-
calibration and after select the desired filter for the application.
If echo filtering is necessary, set the transmitter to filter 3 during calibration in order to
-
access this menu and after select the desired filter for the application.
8175
CALIBRATION MENU
FILTER 0
ENTER
0......9
FILTER 9
OPEN TAN
CLOSED
DOME
DOME+
ENTER
0......9
31
DELA=000
Delay in
Seconds
0......9
DELA=300
ENTER