4.4 CALIBRATION MENU
ENTER
PRESS
The following parameters can be set within this menu:
LANGUAGE
UNIT
FILTER
GAS COMP
ECHO
0......9
TEACH-IN
CURRENT
RELAY
END
The following sections explain how to change the parameter values within the calibration
menu above.
CALIBRATION MENU
SIMULTANEOUSLY FOR 5 SECONDS
Function
Selection between English, German, French,
Italian or Spanish.
Selection of engineering units for level, distance
or volume.
Damping selection and delay time setting for
signal failure alarm. There are ten different steps
available. (Range 0 to 9).
Gas characteristics (velocity of sound and tem-
perature influence).
Selection of the target level and if there are any
fixed echos to be filtered and eliminated by the
transmitter.
Manual or automatic determination of the speci-
fic application parameters.
Setting of the 4-20mA output signal range.
Parameter definition of relays 1 & 2.
Back to the operation mode; store the new
parameters set.
28
Paragraph
4.4.1
4.4.2
4.4.3
4.4.4
4.4.5
4.4.6
4.4.7
4.4.8
8175