Table des Matières
Publicité
Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/26/2019 7:45:42 AM
1 - INSTALLATION MANUAL SERIES 3.5 ENGLISH
6.2.3
Gasket
The glass gasket is flat, adhesive-backed, woven fibreglass. The gasket must be centred on the
edge of the glass.
1.
Follow the steps of the previous section to
remove the glass.
2.
Remove the old gasket and clean the glass
thoroughly.
3.
Peel back a section of the paper covering the
adhesive and place the gasket on a table with
the adhesive side up.
4.
Stick the end of the gasket to the middle of
one edge, then press the edge of the glass
down onto the gasket, taking care that it is
perfectly centred on the gasket.
5.
Peel off more of the backing and rotate the
glass. The gasket must not be stretched
during installation.
6.
Cut the gasket to the required length.
7.
Pinch the gasket onto the glass in a U shape,
all around the glass.
6.3
Door
In order for the insert to burn at its best efficiency, the door must provide a perfect seal with the
firebox. The tightness of the door seal can be verified by closing and latching the door on a strip
of paper. The test must be performed all around the door. If the paper slips out easily anywhere,
either adjust the door or replace the gasket.
Page 20
Stove Builder International Inc. | 44826 | Rev: May 31 2019 2:49PM | Uncontrolled Copy
Figure 7: Door gasket seal verification
(20 OF 37)
Figure 6: Glass Gasket
Installation and operation manual - 3.5 Series
Page 27 of 425
Publicité
Chapitres
Table des Matières
