Table des Matières
Publicité
Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/26/2019 7:45:42 AM
TEST REPORT 103536746MTL-002
TEST REPORT FOR STOVE BUILDER INTERNATIONAL INC.
Report No.: 103536746MTL-002
Date: 07/13/18
Where:
Et
i
The average heat output rate over any time interval shall be calculated as follows:
where
e
t
t
The total heat output during the burn shall be calculated as the sum of all the heat outputs over
each time interval, as follows:
Where:
E
d
E
t
The efficiency shall be calculated as the total heat output divided by the total energy input,
expressed as a percentage as follows:
Where:
E
d
I
SECTION 9
TEST SPECIMEN DESCRIPTION
The model Solution 3.5 Series Wood Fuel Room Heater is constructed of sheet steel. The outer
dimensions are 33.75-inches deep, 34.438.-inches high, and 27.563-inches wide. The unit has a
door located on the front with a viewing glass.
SECTION 10
TEST RESULTS
DESCRIPTION OF TEST RUNS:
RUN #1 (May 22
with a category "low burn rate" of 1.5 kg/hr. Let the door ajar for 6.5 minutes, and then closed.
Version: 05/10/17
Stove Builder International Inc. | 44826 | Rev: May 31 2019 2:49PM | Uncontrolled Copy
E
= ∑(Δe × i) for i= t
to t
t
1
2
= delivered heat output over any time interval t
= time interval for each measurement, h
e
= E
/t
t
t
= average heat output, kJ/h
= time interval over which the average output is desired, h
E
= ∑(E
) for t = t
to t
d
t
0
final
= heat output over a burn, kJ/h (Btu/h)
= heat output during each time interval, kJ/h (Btu/h)
Efficiency, % = 100 × E
/I
d
= total heat output of the appliance over the test period, kJ/kg
= input energy (fuel calorific value as-fired times weight of fuel charge), kJ/kg (Btu/lb)
nd
2018) Air control was set at the targeted burn rate, burn time was 510 minutes
(16 OF 21)
–t
, kJ
2
1
Page 16 of 21
8431 Murphy Drive
Middleton, WI 53562
Telephone: 608-836-4400
Facsimile: 608-831-9279
www.intertek.com/building
GFT-OP-10c
Page 342 of 425
Publicité
Chapitres
Table des Matières
