Table des Matières
Publicité
Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/26/2019 7:45:42 AM
1 - INSTALLATION MANUAL SOLUTION 3.5 ENGLISH
6.2 Regulations Covering Stove Installation
When installed and operated as described in these instructions, the Solution 3.5 wood stove is
suitable for use as a freestanding heater in residential installations. The Solution 3.5 wood stove is
not intended for installation in a sleeping room of a mobile home.
In Canada, the CSA B365 Installation Code for Solid Fuel Burning Appliances and Equipment and
the CSA C22.1 Canadian National Electrical Code are to be followed in the absence of local code
requirements. In the USA, the ANSI NFPA 211 Standard for Chimneys, Fireplaces, Vents and
Solid Fuel-Burning Appliances and the ANSI NFPA 70 National Electrical Code are to be followed
in the absence of local code requirements.
This stove must be connected to a chimney complying with the requirements for Type HT
chimneys in the Standard for Factory-Built Chimneys for Residential Type and Building Heating
Appliances, UL 103 and ULC S629 or to a code-approved masonry chimney with a flue liner.
7 Clearances to Combustible Material
No part of the stove or flue pipe may be located closer to combustibles than the minimum
clearance figures given.
7.1 Location of the certification label
Since the information given on the certification label affixed to the appliance always overrides the
information published, in any other media (owner's manual, catalogues, flyers, magazines and/or
web sites) it is important to refer to it in order to have a safe and compliant installation. In addition,
you will find information about your stove (model, serial number, etc.). You can find the certification
label on the back of the stove.
26
Stove Builder International Inc. | 44826 | Rev: May 31 2019 2:49PM | Uncontrolled Copy
Solution 3.5 Installation and Operation Manual
(26 OF 57)
Page 108 of 425
Publicité
Chapitres
Table des Matières
