EUROM Cool Perfect 90WIFI Livret D'instructions page 17

temperature will increase by one degree up to a maximum of 31°.
7. Timer
Use this button to control the automatic activation and deactivation of the Cool Perfect.
Switching on: The device activates automatically when the set time has expired.
 Activate the device with the function and at the temperature that you desire.
 Switch the device off with the 'power' button.
 Press the 'timer' button.
 Set the number of hours (max. 24) with the 'temp+' or 'temp-' button and press another time
the 'timer' button.
 The device will start automatically after this number of hours.
Switching off: When the set time has elapsed the device will switch off automatically.
 Press the 'timer' button while the device is activated.
 Set the number of hours (max. 24) with the 'temp+" or 'temp-' button.
 The device will switch off automatically when this number of hours has elapsed.
If you press the 'POWER' button before the set time has elapsed you switch the device either
on or off and the timer setting is deleted.
8. Mode = Function selection
Press once or more on this button to select a function: cool, dehumidify, fan or heat. The
corresponding indicator on the control panel lights.
If you wish to heat you must first change the hose connections. See 'Heating'!
If you wish to dehumidify, first connect the water outlet (see page 15).
Alarm
When the tank is full, the Cool Perfect stops. The WF-indicator starts burning and after 5
minutes the display shows 'E2'. Switch the Cool Perfect off, remove the plug from the socket
and remove button A and cap B on the water outlet underneath the unit to drain water. Replace
button A and cap B and you can start the Cool Perfect as usual.
LED-display
The display shows whether power is connected and the temperature or timer settings. If
settings are amended, the display will show the new setting and then revert back to displaying
the set temperature.
The display also shows error codes, see later in the leaflet.
Memory
The Cool perfect has a memory. If the electricity supply is disrupted and then resumed it will
return to operation in the last mode. If you have switched the device off with the Power button
(as recommended) and then removed the plug from the socket, it will return to the stand-by
setting when you re-connect the power supply. You must then select the desired function again.
Via remote control:
The remote control provides the same options as the buttons 1-8 on the control panel.
Via an app (Cool Perfect 150WIFI)
The perfect Cool 150WIFI can, via Wi-Fi, also be operated by an app. See the separate app
instruction.
 When you start the Cool Perfect and select a certain function or change the function, the fan will
start up but the compressor will not begin to work immediately; this is to protect the internal
components. The symbol that corresponds to the display (see diagram) will blink to show it is
'waiting'. This can take 3 to 4 minutes.
 The horizontal fins for the outlet opening can be adjusted manually to change the outlet
direction.
17