Additional Information Regarding Performance; Storage - Tippmann TPX Marker Manuel D'utilisation

ADJUSTABLE CO2 CARTRIDGE (continued from page 25)
WARNING
E
KEEP EXPOSED SKIN AWAY FROM ESCAPING
GAS WHEN INSTALLING OR REMOVING AIR
N
SUPPLY CARTRIDGE OR IF THE MARKER OR AIR
G
SUPPLY IS LEAKING.
L
COMPRESSED AIR, CO2, AND NITROGEN GASSES ARE VERY COLD AND
I
CAN CAUSE FROSTBITE UNDER CERTAIN CONDITIONS.
S
7) Reinstall the CO cartridge. If the cartridge punctures without pulling
2
H
the trigger, the adjustment screw is set too deep. If you pull the trigger
all the way and the cartridge does not puncture, the screw is set too
shallow.
8) Remove and dispose of the CO
12). Because manufacturer's tolerances vary for CO
steps 1 through 6 may need to be repeated in order to find the optimal
setting for your brand of CO

Additional Information Regarding Performance

1) For best results, and to keep your TPX pistol running at peak
performance, it is recommended that you use a paintball that is
not too old or fragile and free of dimples or defects. Tippmann also
discourages leaving paint in magazines for an extended period of time
as this can lead to the paintball deforming. Only load magazines the
day of play.
2) To determine if the paintballs are appropriate for the use with the TPX
pistol, press the tip of your fingernail against a paintball to determine
if it is easily dimpled. If the paintball dimples, this paint should not be
used in the TPX pistol.
3) Please thoroughly read this TPX manual, and in particular, review
the "Magazine Removal, Loading, and Insertion" instructions before
loading your magazine. Proper loading will ensure proper feeding of
the paintballs into your TPX pistol.
cartridge (see Unloading on page
2
cartridge length,
2
cartridge.
2
26

Storage

Before storage, follow the "Unloading and Air Supply Cartridge Removal"
instructions on page 12 (on page 21 for markers with remote line adaptor
installed). Do not store a marker with any of the following installed:
• 12 gram air supply cartridge (punctured or unpunctured)
• an air supply cylinder
• magazine
Store the magazine empty, with the follower tab in the top position.
Put the trigger safety in Safe Mode (see page 4) and install the barrel
blocking device (see page 2). You should store your marker in a dry area.
Before storing your marker, make sure that the marker is cleaned and
lubricated (see cleaning and maintenance on page 14) so that it does not
rust.
When removing your marker out of storage, make sure to put the trigger
safety in safe mode (see page 4) and install the barrel blocking device
(see page 2). You should re-lubricate before use (see cleaning and
maintenance on page 14).
27
E
N
G
L
I
S
H