Tools Required For Assembly; Assembling & Preparing Your Grill - Jackson Grills Supreme JSS550BI-LP Manuel D'utilisation

Please use the proper tools to simplify installation and prevent injury or damage to your grill.
◼ Installer Supplied Tools:
1 x Large Phillips Screwdriver
1 x Medium Phillips Screwdriver
1 x OPTIONAL: Socket wrench with 6mm Socket and extension
Assembling & Preparing your Grill:
◼ CHECK BURNER FIT on ORIFICES:
1. Inspect burners to ensure that they are all inserted correctly onto the orifices (AKA
the outlet of the valves; Fig 1)
2. If any burner is NOT correctly installed over the valve as shown in Fig 1, remove the
burner retaining clip, remove the burner, and reinstall correctly.
3. Ensure each air shutter is set correctly – see correct flame characteristics on page
15 to see if it needs adjusting. Although we have pre-set the air shutters on the burners of this product, it may
be necessary to adjust them for optimum performance. This is an outdoor appliance and geography and
climate can necessitate an adjustment to the air shutters. The correct flame characteristics can be found on
page 15 of your owner's manual.
◼ INSTALL FLAME DIFFUSERS & COOK GRIDS:
1. Remove the flame diffusers, grids & warming rack from the packaging.
2. Install each diffuser directly above each burner by setting them into the slotted
ledges, in the front and rear of the firebox. (Fig. 2)
3. Once the flame diffusers have been installed, set the cooking grids on the
upper ledges of the firebox in the grill, with the grill bars oriented front to rear.
4. Install the warming rack above cook grids, on the 2 brackets located on the left
& right inner walls of the inner hood.
◼ PREPARE REAR ROTISSERIE BURNER IGNITER:
1. Unscrew the plastic/rubber cap from the rear burner ignition module, and insert
AAA battery (supplied) with the positive end facing out. (Fig. 3)
2. Re-install cap.

Tools Required for Assembly:

Tip of brass orifice, on
end of valve; correctly
hidden inside burner.
7
Figure 1
Main burner
Figure 2
Figure 3