Tools Required For Assembly; Assembling & Preparing Your Grill - Jackson Grills LUX700 Manuel Du Propriétaire

Please use the proper tools to simplify installation and avoid injury or damage to your grill.
 INSTALLER SUPPLIED TOOLS:
1 x Large Phillips Screwdriver
1 x Small Phillips Screwdriver
1 x Small Crescent Wrench
1 x Large Crescent Wrench
Assembling & Preparing your Grill:
 CHECK BURNER FIT on ORIFICES:
1. Inspect burners to ensure that they are all inserted correctly onto the orifices
(AKA the outlet of the valves; Fig 1)
2. If any burner is NOT correctly installed over the valve as shown in Fig 1,
remove the burner retaining clip, remove the burner, and reinstall correctly.
3. Ensure each air shutter is set correctly – closed for natural gas, or ¼" open
for propane gas (see diagram on page 20). Although we have pre-set the air
on the burners of this product, it may be necessary to adjust them for optimum performance. This is an
outdoor appliance and geography and climate can necessitate an adjustment to the air shutters. The
correct flame characteristics can be found on page 15 of your owner's manual.
 INSTALL FLAME DIFFUSERS & COOK GRIDS:
1. Remove the flame diffusers, grids & warming rack from the packaging.
2. Install each diffuser directly above each burner by setting them into the slotted
ledges, in the front and rear of the firebox. (Fig. 2)
3. Once the flame diffusers have been installed, set the cooking grids on the
upper ledges of the firebox in the grill, with the grill bars oriented front to rear.
4. Install the warming rack above cook grids, on the 2 brackets located on the left
& right inner walls of the inner hood.
 PREPARE REAR BURNER IGNITER:
1. Unscrew the plastic/rubber cap from the rear burner ignition module, and insert
supplied AAA battery with the positive end facing out. (Fig. 3)
2. Re-install cap.
 INSTALL SIDE SHELVES (2):
1. Install both Side Shelves, using 4 screws per shelf (supplied). (Fig. 4 Next
Page)
2. Drop Cutting Board into opening in RH Side Shelf (Fig. 5)

Tools Required for Assembly:

Tip of brass orifice, on
end of valve; correctly
hidden inside burner.
7
Figure 1
Main burner
shutters
Figure 2
Figure 3