Clearance To Combustibles - Jackson Grills LUX700 Manuel Du Propriétaire

3.
Figure 4
INSTALL ROTISSERIE KIT: (For Rotisserie Cooking)

1. Carefully remove the rotisserie kit parts from the packaging.
2. Install the motor mounting bracket supplied to the left hand side of the inner hood. (Fig. 6)
3. Install the motor on the motor bracket.
4. Place the forks and counter balance on the rotisserie rod in the desired location.
5. Place the rotisserie rod into the motor. Align the rotisserie rod groove over the right inner hood wall and
drop it into the cut out provided on the inner hood. (Fig.7)
Figure 6
 INITIAL CLEAN/WIPE DOWN:
Because we use high polish detailing, there may be some residue from the light oily cleaner we
use to take off the protective plastic residue and masking. These marks can be easily cleaned
using a 3M stainless cleaner and a microfiber cloth, always cleaning in the direction of the
stainless steel grain. This is a food safe cleaner that is non-abrasive and will leave your BBQ
gleaming. This cleaner can be used for future regular cleaning.
A) TOP: Minimum clearance from grill surface to combustible construction*:
*Such as decks, ceilings, hanging plants, etc.
B) REAR: from rear of unit to any combustibles behind grill:
C) SIDE: from the outside edges of the barbecue unit (excluding side shelves) to any adjacent
combustibles:
Please allow extra space when the grill is backed up to vinyl siding;
exhaust exiting the rear of the grill can warp or melt the vinyl.
Phillips Head
Mounting Screws
(Included)
Figure 7

Clearance to Combustibles:

!WARNING!
8
Figure 5
Rotisserie Kit installed
Do not use this appliance
under overhead
combustible surfaces.
12 inches minimum
15.5 inches minimum