Clearance To Combustibles - Jackson Grills LUX Serie Manuel Du Propriétaire

INSTALL SIDE SHELVES (2): (Installation Not Required for JLS400-LP/NG or Built-In Models)
◼
1. Install both folding Side Shelves, using 4 screws per shelf (supplied). (Fig. 4)
INSTALL ROTISSERIE KIT: (For Rotisserie
◼
Cooking)
1. Carefully remove the rotisserie kit parts from the packaging.
2. Install the motor mounting bracket supplied to the left hand side of the inner
hood. (Fig. 5)
3. Install the motor on the motor bracket.
4. Place the forks and counter balance on the rotisserie rod in the desired location.
5. Place the rotisserie rod into the motor. Align the rotisserie rod groove over the right inner hood wall and
drop it into the cut out provided on the inner hood. (Fig.6)
Figure 5
INITIAL CLEAN/WIPE DOWN:
◼
Because we use high polish detailing, there may be some residue from the light oily cleaner we use to take
off the protective plastic residue and masking. These marks can be easily cleaned using a 3M stainless
cleaner and a microfiber cloth, always cleaning in the direction of the stainless steel grain. This is a food safe
cleaner that is non-abrasive and will leave your BBQ gleaming. This cleaner can be used for future regular
cleaning.
Clearance to Combustibles: ALL LUX Models
A) TOP: This appliance shall not be located or used under overhead unprotected combustible
construction.
B) REAR: from rear of unit to any combustibles behind grill: 12 inches minimum
C) SIDE: from the outside edges of the barbecue unit (excluding side shelves) to any adjacent
combustibles: 15.5 inches minimum
Please allow extra space when the grill is backed up to vinyl siding;
exhaust exiting the rear of the grill can warp or melt the vinyl.
Phillips Head
Mounting Screws
(Included)
Figure 6
!WARNING!
8
Figure 4
Rotisserie Kit installed