Clearance To Combustibles; Propane Gas Connection - Jackson Grills Keystone Série Manuel D'utilisation

A) TOP: This appliance shall not be located or used under overhead unprotected combustible
construction.
B) REAR: from rear of unit to any combustibles behind grill: 12"/30.48 cm minimum
C) SIDE: from the outside edges the grill body, to any adjacent combustibles: 15 ½"/39.37 cm minimum
Please allow extra space when the grill is backed up to vinyl siding;
exhaust exiting the rear of the grill can warp or melt the vinyl.
CARTS: INSTALLING & CONNECTING A PROPANE CYLINDER TO THE GRILL:
◼
1. Make sure tank valve is in its full off position (turn clockwise to stop).
2. Check tank valve to ensure that is equipped with external (male) threads (i.e. QCC-1 type connecter).
3. Make sure all burner knobs are in their off position.
4. Remove the protective dust cap from the cylinder valve. Always reuse dust cap when storing a cylinder.
5. Inspect valve connection port and regulator; look for any damage or debris. Inspect hose for damage.
Never attempt to use damaged or plugged cylinders. Contact your local propane gas dealer for repair.
6. Remove the Pedestal Base Access Cover. (Fig. 4)
7. Place the Propane Tank into the Tank Mounting Hole in the pedestal of the grill. (Fig. 5). Always install the
propane cylinder in an upright position with the valve at the top, to facilitate vapor withdrawal (Fig. 5).
8. Attach the Propane Hose and Regulator by hand-tightening the black plastic Quick Coupling Connecter
(QCC) nut clockwise to a positive stop. Do not use a wrench to tighten as this may damage the nut and
cause leaks. (Fig. 6)
Figure 4
9. Open tank valve SLOWLY (counterclockwise) until fully open. Use a soapy water solution to check all
connections for leaks before lighting grill. If a leak is found DO NOT use the grill. Turn gas off and call a
professional gas fitter to repair the leak.
DISCONNECTING PROPANE CYLINDER:
◼
1. Turn all the grill knobs to off.
2. Turn the tank valve off fully (turn clockwise to stop).
3. Detach the regulator from tank valve by turning the black (QCC) nut counterclockwise.
4.
Install the protective cap back onto the threads of the propane cylinder valve.

Clearance to Combustibles:

!WARNING!

Propane Gas Connection:

Tank Mounting Hole
Figure 5
8
Figure 6