Jackson Grills Keystone Série Manuel D'utilisation page 13

•
Push in and rotate each control knob counter clockwise slowly, to the HI position. (When rotating the knob,
rotate for a two to four second count: do NOT turn the knob rapidly) The built-in igniter
thus lighting the torch light pilot flame, then the main burner. If the burner does not light IMMEDIATELY turn the
knob to off and wait 5 minutes for gas to dispel and repeat the lighting procedure.
•
Follow match lighting instructions if burner can't be lit after repeating 3-4 times.
HIGH setting
& Ignition
3. TO LIGHT MAIN BURNERS USING A MATCH OR BARBECUE LIGHTER:
(Temporary Solution when Ignition is disabled)
•
Read instructions before lighting.
•
Open the lid during lighting, and remove cook grids.
•
Turn all knobs to "OFF" then open the propane cylinder valve, OR natural gas valve on your gas connection.
NOTE: Always keep your face and body averted when lighting.
•
A long stove match or BBQ lighter must be used to reach the burners.
•
Do NOT drop a burning match into grill for lighting purposes; hold the match in the desired spot.
•
Push and turn the main burner knob to the HI position, then release.
•
Light burner by match at the front end of the burner tube. Make sure the burner lights and stays lit.
•
If necessary, call your dealer or the Jackson help line, for assistance with repairing your ignition system.
4. FLAME CHARACTERISTICS: (Fig. 14)
•
Check for proper burner flame characteristics. Each burner is adjusted prior to shipment; however, variations in
the local gas supply may mean subtle adjustments may be necessary.
•
Burner flames should be blue and stable. There should be no excessive noise, or flame lifting. If any of these
conditions exist please call your Dealer. If the flame is yellow, it indicates insufficient air. If the flame is noisy and
tends to lift away from the burner, it indicates too much air.
•
NOTE: small yellow tips are okay.
Excellent Flames: mostly
blue, small amount of yellow
is okay; flames are even sized
and calm.
. . . . . . . . . . . . . . . . .
Figure 13
OFF setting
LOW setting
Figure 14
Problem Flames: lifting off,
'ghosting' and disappearing;
check shutter settings. (see pg.
20)
Main Burner
13
Problem Flames: uneven,
blasting, noisy with lots of yellow;
check for burner blockage, foreign
material, insect nests (pg. 19, 20)
will click and spark,