Installer Final Checklist; Fuel Conversion; Grill Lighting Instructions; Before Lighting - Jackson Grills Keystone Série Manuel D'utilisation


Ensure that clearances to combustible materials are maintained per specifications listed in this manual.

Make sure that all internal packaging has been removed.

Check that the burners are sitting properly on orifice end of the valves. (Pg.7)

Check grill label to confirm that the gas configuration matches the fuel being supplied

When using natural gas, ensure the appliance pressure (between NG regulator and main manifold) is at 4" WC
with a maximum 7"WC entering the regulator.

For propane grills confirm that inlet pressure is at 11" WC; NOTE that the original Jackson regulator and hose
are preset to 11" WC.

Ensure that all the gas knobs turn freely.

Leak test grill and all gas connections.

Grill test fired, and all functions working and in good order.

User informed of gas supply shut off valve location.

Owner's manual given to grill user.
This grill is convertible to Natural Gas or Propane when needed, with the installation of the appropriate Gas Conversion
Kit (See parts list, Pg. 20-21). The kit should be installed by a qualified gas fitter. Please contact your local dealer for
information.

1. BEFORE LIGHTING:

• Always inspect the gas supply hose before turning the gas "ON". If there is evidence of cuts, wear, or abrasion, it must
be replaced before use. Use only a manufacturer approved replacement hose.
• Check all gas connections for leaks before each use. Do not light grill if gas odor is present.
2. TO LIGHT MAIN BURNERS OF THE GRILL: (see Fig. 13)
• Read instructions before lighting (see labels on top edge of the pull-out grease tray)
• Open lid prior to lighting your grill.
• Turn all knobs to "OFF" then open the propane cylinder valve, OR natural gas valve on your gas connection. NOTE:
Always keep your face and body averted when lighting.
Installer Final Check List:

Fuel Conversion:

Grill Lighting Instructions:

Optional Smoker Chip Box
12