Clearance To Combustibles - Jackson Grills LUX550 Manuel D'utilisation

 INSTALL SIDE SHELVES (2):
1. Install both Side Shelves, using 4 screws per shelf (supplied).
(Fig. 4 Next Page)
2. Drop Cutting Board into opening in RH Side Shelf (Fig. 5)
INSTALL ROTISSERIE KIT: (For Rotisserie Cooking)

1. Carefully remove the rotisserie kit parts from the packaging.
2. Install the motor mounting bracket supplied to the left hand side of the inner hood.
(Fig. 6)
3. Install the motor on the motor bracket.
4. Place the forks and counter balance on the rotisserie rod in the desired location.
5. Place the rotisserie rod into the motor. Align the rotisserie rod groove over the right
inner hood wall and drop it into the cut out provided on the inner hood. (Fig.7)
Figure 6
 INITIAL CLEAN/WIPE DOWN:
Because we use high polish detailing, there may be some residue from the light oily cleaner we
use to take off the protective plastic residue and masking. These marks can be easily cleaned
using a 3M stainless cleaner and a microfiber cloth, always cleaning in the direction of the
stainless steel grain. This is a food safe cleaner that is non-abrasive and will leave your BBQ
gleaming. This cleaner can be used for future regular cleaning.
A) TOP: from top of hood to any combustibles above grill:
*Such as decks, ceilings, hanging plants, etc.
B) REAR: from rear of unit to any combustibles behind grill:
C) SIDE: from the outside edges of the barbecue unit (excluding side shelves) to any adjacent
combustibles:
Please allow extra space when the grill is backed up to vinyl siding;
exhaust exiting the rear of the grill can warp or melt the vinyl.

Clearance to Combustibles:

!WARNING!
Phillips Head
Mounting Screws
(Included)
Figure 7
8
Rotisserie Kit installed
Do not use this appliance under
overhead combustibles.
12 inches minimum
15.5 inches minimum
Figure 4
Figure 5