Tools Required For Assembly - Jackson Grills Versa 100 Manuel D'utilisation

1 x
1 x
•
Please ensure all components have been supplied with this appliance before assembly or operation begins.
•
Please remove all packaging materials before using this portable grill.
Assembling & Preparing Your Grill:
STEP 1:
Install the hood handle by opening the hood and placing the Stainless Steel hood handle spacers (flat side down)
over the handle mounting holes. Place the handle on the handle spacers and screw in the bolts from inner side of the
hood. Do not over tighten and be careful not to cross thread the bolts into the handle.
STEP 2:
Insert diffuser into holes located at the bottom of the inner grill tub (right)
STEP 3:
Remove grill grates from protective plastic bag and Insert into the
support holes (4 grates, 16 holes).
STEP 4:
Place the unit in the upright position and screw in the supplied portable
regulator. (Fig. 2) Do not over tighten. Lubricate the threads of the regulator valve with petroleum jelly, insert the gas
cylinder onto the regulator valve and hand tighten firmly. Disconnect the gas cylinder when the appliance is not in use.
DO NOT obstruct the flow of combustion air and ventilation air to this portable grill.
Fig. 2: Screw the brass nut
of the regulator into the
side of the control box.
STEP 4:
Install the supplied battery in the ignition module. (Fig. 3). To do so, unscrew the black
igniter button (cap) by turning it counter clockwise. The igniter works only if the battery is
installed in the correct direction.

Tools Required for Assembly:

# 2 Phillips Screw Driver
Small Crescent Wrench
!WARNING!
Use ONLY the Regulator supplied
with this Grill. Use ONLY authorized
Jackson Replacement Parts.
Do not over tighten the brass
nut as it may crack or break;
slightly tighter than finger tight
is sufficient.
TECH TIP
7