Tools Required For Assembly; Assembling & Preparing Your Grill - Jackson Grills LUX700BI Manuel D'utilisation

Please use the proper tools to simplify installation and prevent injury or damage to your grill.
 Installer Supplied Tools:
1 x Large Phillips Screwdriver
1 x Medium Phillips Screwdriver
1 x OPTIONAL: Socket wrench with 6mm
Socket and extension
Assembling & Preparing your Grill:
 CHECK BURNER FIT on ORIFICES:
1. Inspect burners to ensure that they are all inserted
correctly onto the orifices (AKA the outlet of the valves; Fig 1)
2. If any burner is NOT correctly installed over the valve as shown in Fig 1,
remove the burner retaining clip, remove the burner, and reinstall correctly.
3. Ensure each air shutter is set correctly – closed for natural gas, or ¼" open for
propane gas (see diagram on page 21). Although we have pre-set the air
shutters on the burners of this product, it may be necessary to adjust them for optimum performance. This
is an outdoor appliance and geography and climate can necessitate an adjustment to the air shutters. The
correct flame characteristics can be found on page 16 of your owner's manual.
 INSTALL FLAME DIFFUSERS & COOK GRIDS:
1. Remove the flame diffusers, grids & warming rack from the packaging.
2. Install each diffuser directly above each burner by setting them into the slotted
ledges, in the front and rear of the firebox. (Fig. 2)
3. Once the flame diffusers have been installed, set the cooking grids on the
upper ledges of the firebox in the grill, with the grill bars oriented front to rear.
4. Install the warming rack above cook grids, on the 2 brackets located on the left
& right inner walls of the inner hood.
 PREPARE REAR BURNER IGNITER:
1. Unscrew the plastic/rubber cap from the rear burner ignition module, and insert
AAA battery (supplied) with the positive end facing out. (Fig. 3)
2. Re-install cap.
 INSTALL ROTISSERIE KIT: (For Rotisserie Cooking)
1. Carefully remove the rotisserie kit parts from the packaging.
2. Install the motor mounting bracket supplied to the left hand side of the inner hood. (Fig. 4)
3. Install the motor on the motor bracket.
4. Place the forks and counter balance on the rotisserie rod in the desired location.

Tools Required for Assembly:

Tip of brass orifice, on
end of valve; correctly
hidden inside burner.
7
Figure 1
Main burner
Figure 2
Figure 3