Cutout (Framing) Dimensions - Jackson Grills LUX700BI Manuel D'utilisation

5. Place the rotisserie rod into the motor. Align the rotisserie rod groove over the right inner hood wall and
drop it into the cut out provided on the inner hood. (Fig.5)
Figure 4
 INITIAL CLEAN/WIPE DOWN:
Because we use high polish detailing, there may be some residue from the light oily cleaner we use to take
off the protective plastic residue and masking. These marks can be easily cleaned using a 3M or Sprayway
stainless cleaner and a microfiber cloth, always cleaning in the direction of the stainless steel grain. This is a
food safe cleaner that is non-abrasive and will leave your BBQ gleaming. This cleaner can be used for future
regular cleaning.
Cut Out (Framing) Dimensions:
Installing in an outdoor cabinet:
A.
This grill must be safely and correctly installed as a built in unit, before being used. Please refer to the chart below,
for correct installation dimensions.
Framing must enclose the grill on the back and sides, but the bottom of the cut-out may be left open. The grill is
supported by the three flanges (left, right and rear), so no support underneath is required. NOTE: please ensure
that fuel line openings provide adequate space for the lines,
CABINET FRAMING DIMENSIONS:
*NOTE: Rear cabinet back splash (if applicable) and counter top must be non-combustible.
A
D
B
C
Figure 5
E
F
MODEL
Lux
JLS 700Bi
*B
*C
*D
*E/F
Built In Grill Cutout Dimensions
Cabinets with Non-Combustible Materials
(Eg: metal studs, cement board, tiles, marble)
A B*
Width Depth
33" 18 ¾"
Depth is measured from the finished face of the
island/cabinet. Notching of countertop front may
be required.
Height is measured from the finished countertop
down.
Minimum distance to rear vertical wall; required
to fully open lid (from cutout).
Minimum distance to side/rear adjacent vertical
combustibles.
8
Rotisserie Kit installed
C* D* E*
Height
10" 5 ½" 12" 15.5"
F*