Low Setting - Jackson Grills Supreme JSS550BI-LP Manuel D'utilisation

HI setting
& Ignition
3. TO LIGHT MAIN BURNERS USING A MATCH OR BARBECUE LIGHTER:
(Temporary Solution when Ignition is disabled)
•
Read instructions before lighting.
•
Open the lid during lighting, and remove cook grids.
•
Turn all knobs to "OFF" then open the propane cylinder valve, OR natural gas valve on your gas
connection. NOTE: Always keep your face and body averted when lighting.
•
A long stove match or BBQ lighter must be used to reach the burners.
•
Do NOT drop a burning match into grill for lighting purposes; hold the match in the desired spot.
•
Push and turn the main burner knob to the HI position, then release.
•
Light burner by match at the front end of the burner tube. Make sure the burner lights and stays lit.
•
If necessary, call your dealer or the Jackson help line, for assistance with repairing your ignition system.
4. FLAME CHARACTERISTICS: (Fig. 11)
•
Check for proper burner flame characteristics. Each burner is adjusted prior to shipment; however,
variations in the local gas supply may mean subtle adjustments may be necessary.
•
Burner flames should be blue and stable. There should be no excessive noise, or flame lifting. If any of
these conditions exist please call your Dealer. If the flame is yellow, it indicates insufficient air. If the flame is
noisy and tends to lift away from the burner, it indicates too much air.
•
NOTE: small yellow tips are okay.
Excellent Flames: mostly blue,
small amount of yellow is okay;
flames are even sized and calm.
. . . . . . . . . . . . . . . . .
OFF setting
Figure 10

LOW setting

Figure 11
Problem Flames: lifting off,
'ghosting' and disappearing; check
shutter settings. (see pg. 20)
Main Burner
15
Problem Flames: uneven,
blasting, noisy with lots of yellow;
check for burner blockage, foreign
material, insect nests (pg. 19, 20)