Storage; Storage Conditions; Preparing For Storage; Storage Of The Chemical Protective Suit - Dräger CPS 6800 Notice D'utilisation

7

Storage

7.1

Storage conditions

CAUTION
!
If you fail to ensure proper storage conditions, the
chemical protective suit may be damaged!
Store the chemical protective suit in a dark, cool, dry and

airy place without pressure or stress.
Keep out of UV light and direct sunlight; avoid ozone.

Observe the storage temperature (see Chap. 9 on

Page 37).
7.2

Preparing for storage

1. Close the fastener system up to approx. 5 cm before the
end. Regularly check whether the fastener system is still
adequately greased.
2. Pull the flat bag supplied over the hood.
3. If the chemical protective suit is folded together, pull the
supplied flat bag over the safety boots so that the chemical
protective suit is not discoloured.
7.3

Storage of the chemical protective suit

The following storage options are possible:
Lay the chemical protective suit flat during storage. If the

chemical protective suit is stored in the utility vehicle, avoid
wear due to constant friction against the storage surface.
Hang up the chemical protective suit on an appropriate

hanger or a hanging rail. The hood or protective boots must
be in contact with the ground.
Fold up the chemical protective suit and store it in a

transport case, storage bay or carrying bag.
Pack the chemical protective suit in a CPS storage and

transportation bag.
NOTICE
i
i
Dräger recommends packing the chemical protective
suit in the CPS storage and transportation bag to
protect it from environmental influences and to extend
maintenance intervals.
Dräger CPS 6800
7.3.1 Folding up the chemical protective suit
NOTICE
i i
Fold up the depressurized chemical protective suit
carefully.
Do not use force to bend the suit material, seams and
fastener system in the process. Avoid sharp bends.
1. For a permanently fitted
full face mask:
a. Pull the flat bag over
the full face mask and
the hood.
2. Turn up the socks or
protective boots twice.
Avoid sharp bends.
3. Place the sleeves into the
centre of the chest section.
Smooth out any creases.
4. Fold the hood and top
section of the chemical
protective suit so that they
are positioned on
rolled up protective boots.
Smooth out any creases.
the
Storage
00821986.eps
00921986.eps
01021986.eps
01121986.eps
35