Responsibility; Transport, Handling And Storage; Transport And Handling; Storage - DAB 1 KVT Instructions Pour L'installation Et La Maintenance

2.3.

Responsibility

The Manufacturer does not vouch for correct operation of the set or for any damage that it may cause if it
has been tampered with, modified and/or run outside the recommended work range or without the aid of
our control and protection panels.
The Manufacturer declines all responsibility for possible errors in this instructions manual, if due to
misprints or errors in copying. The Manufacturer reserves the right to make any modifications to
products that it may consider necessary or useful, without affecting their essential characteristics.
3.

TRANSPORT, HANDLING AND STORAGE

3.1.

Transport and handling

To reduce risks during lifting and handling operations, be sure to operate in safety conditions checking that
equipments are complying with safety norms and are suitable for the weights, dimensions and shape of the
product. Handle the product with protective gloves avoiding cut risks to hands. When lifting and placing the
pump be sure of its stability before releasing the lifting equipment.
3.2.

Storage

The products described in this manual must be stored in covered and dry rooms. In case of a long storage period
(over 3 months) and/or storage in conditions with low ambient temperature, you should empty the pump (the
water may freeze and cause serious damages) and protect it with special products against oxidation and rotate
periodically by hand the shaft to avoid the possible locking of the same. Keep the product in vertical position
checking its stability in order to avoid dangerous falls.
3.3.

Packing disposal

The products described in this manual are normally packed in wooden boxes that must be disposed as prescribed
by the local regulations prevailing in the country in which the disposal occurs. For further informations contact
the relevant authorities.
4.

PUMP INSTALLATION

After receiving the product ensure that during transport has not been damaged and that the data reported on the identification
plate of the product correspond to the submitted order.
It is forbidden to use the machines described in this manual for pumping inflammable or dangerous
liquids (petrol, oil, kerosene, etc.) or in potentially explosive atmospheres. The presence of abrasive
substances causes wearing and premature deterioration of the internal components of the pump. The
presence of pollutants, such as residues of hydrocarbon, solvents, detersives, natural gas, may cause heavy
damages producing the blowing of the rubber components (bearings, wear rings) and even the consequent
pump rotor locking.
In case of use in conditions different from the suggested ones or constructive modifications made without
previous authorization, warranty foreseen in the general sale conditions will be no longer valid and the
manufacturer will not be responsible of eventual damages caused to persons, animals or things.
4.1.

Required Equipment

In order to mount your vertical pump without any problem, you will need the following equipment:
Gin
Lifting flange
ENGLISH
Mobile crane
Chain with plates with holes
46
Clamp for pipes
Figure 1