Ayce PLCDL-M136JS-12V Manuel D'utilisation page 45

e. LED light (Fig. 7)
A LED light source is integrated in the housing.
The light is activated as soon as the On/Off switch is pressed.
Abb.7
f. Fully automatic spindle locking (Auto-lock)
When the trigger switch is not pressed, the drill spindle and thus the tool holder are locked.
This enables screws to be screwed in, even when the battery is empty and allows for the machine
to be used as a screwdriver.
g. Run-on brake
When the trigger switch is released, the chuck brakes to a stop, thus preventing the run-on
of the tool. When driving in screws wait until the screw is screwed in flush with the material
and then release the trigger switch. By doing so, the head of the screw does not penetrate into
the material.
4. Operation for working.
a. General drilling
1. Your cordless drill is useful for drilling holes as well as driving and removing screws.
to driver screws on a high speed.
and trying again using less force on the drill. If the drill is straining because the battery
pack charge is low, stop and recharge the battery pack.
speeds for drilling wood and when using polishing accessories. For maximum drill life
use the variable speed control but do not use it continuously in the variable speed range.
Disconnect the charger from the mains supply before cleaning.
b. Hole drilling
1. When attempting to drill a large diameter hole, it is sometimes best to start with a
2. If the drill bit snags, switch off the drill immediately to prevent permanent damage. Try
the reverse drive to remove the bit.
3. Keep the drill in line with the hole. Ideally, if the angle is changed during drilling it
could cause the bit to break, blocking the hole and perhaps causing injury.
4. Frequently remove the drill bit from the hole when drilling deep holes to allow the dust
to be ejected from the hole.
c. Screw driving
1. When driving in larger and/or longer screws in hard material, it is advisable to drill a
pilot hole first, slightly longer and just smaller than the shank diameter of the screw
to be fitted. The pilot hole will act as a guide for the screw and will also make tightening
of the screw less difficult. When screws are positioned close to an edge of the material,
a pilot hole will also help to prevent splitting of the wood.
3. When driving screws, always keep enough pressure on the drill to prevent wearing
of the screw head. It will be difficult to drive or remove a screw if the screw head is worn.
d. Deep discharge protection
This cordless drill is integrated deep discharge protection, when the tool was used heavily,
the discharge protection will operate to cut off inner circuit, after the a few time rests,
discharge protection will reset.
MAINTENANCE
CAUTION!
Always disconnect the device before performing any adjustment or maintenance operation.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage
to remove dirt, carbon dust, etc.
STORING
Store the machine, operating instructions and where necessary the accessories in the
original packaging. In this way you will always have all the information and parts ready
to hand. Pack the device well or use the original packaging in order to avoid transit
damage. Always keep the machine in dry place.
88 | 89
GB
GB GB