Instructions To Navigate Micro-Smart Menus And To Modify Some Parameters - Cattani Micro- Smart Manuel D'utilisation

• Instructions to navigate Micro-Smart
menus and to modify some parameters
Main menus
When Micro-Smart is switched on, the display shows the
Cattani logo for 10 seconds, after which time the main
menu appears.
Main Menu "A1"
This menu shows some parameters such as: cycles, suc-
tion activation time, temperature, presence/absence of the
amalgam container and system software release.
Control Menu "A2"
The display shows the number of times Micro-Smart has
been switched on by means of the main switch (Power
Cycles), the total hours Micro-Smart has had power sup-
plied (Uptime), the number of times suction has been acti-
vated (Work Cycles), the total running hours of the aspira-
tor (Work Time), the average working hours of the blower
(Aspirator) and the number of times the control panel coo-
ling fan has been activated (Fan Cycles).
Events Menu "A3"
This menu shows the last 10 events or alarms that have oc-
curred to Micro-Smart. Alarms are indicated with a number;
refer to the table at page 38 to identify them.
Control Menu "A2"
COUNTERS – ODOM . A2
POWER CYCLES
UPTIME [ h]
WORK CYCLES
WORK TIME [ h]
ASPIRATOR [ h]
FAN CYCLES
000000 Number of times the aspirator has been switched on
by means of the main switch.
000000 Total hours Micro-Smart has had power supplied.
000000 Number of times the aspirator has been activated by
the dental unit.
000000 Number of real running hours (motors running).
000000 Average working hours of the aspiration motor (UNI-
JET 40).
000000 Number of times the control panel cooling fan has
been activated.
29