Handling Electrical Cables; Conventions In This Manual; General Information On The Installation Manual - Dometic SPX1200I Instructions De Montage

CoolAir SPX1200I
• Do not open the system in the event of a fire. Use approved extinguishing
agents instead. Do not use water to extinguish fires.
• Switch off the parking cooler before using automatic washing equipment
(automatic car washes etc.) to clean the vehicle.
• Disconnect all connections to the power supply when carrying out work on
the device.
• The system must be switched off before you tilt the cab.
2.2

Handling electrical cables

• The electrical cables might be laid over sharp edges. Use ducts or tubes to
prevent damage.
• Do not lay loose or bent cables next to electrically conductive materials
(metal).
• Do not pull on the cables.
• Attach and lay the cables in such a manner that they cannot be tripped over
or damaged.
• The electrical power supply may only be connected by a specialist work-
shop.
• Fit a fuse of 25 A to the connection to the vehicle's power supply.
• Never lay power supply lines (battery leads) in the vicinity of signal or control
cables.
• Where neeeded, secure cables with cable binders.
3

Conventions in this manual

3.1

General information on the installation manual

This installation manual contains the essential information and instructions for
installing the parking cooler. The information is intended to be read by the
installation personnel of the parking cooler.
The following instructions are intended to help you use the installation manual
properly:
• The installation manual is part of the scope of delivery and should be stored
carefully.
• The installation manual provides you with important information on the
installation of the device and can also be used as a reference material in the
event of repairs.
EN
Conventions in this manual
5