Sealing And Attaching The Hood; Routing Supply Lines To Condenser Unit; Connecting Condenser Unit To Evaporator Unit - Dometic SPX1200I Instructions De Montage

CoolAir SPX1200I
6.5

Sealing and attaching the hood

A
NOTICE!
When bending the supply line make sure that the radius is not too narrow. Use
a suitable round object with a shim as a bending aid.
A radius which is too narrow will kink the refrigerant line, and this will prevent
the parking cooler from operating.
I
NOTE
If you wish to avoid damaging the cab's rear panel (drilling a hole), you can also
fix the hood in place using a suitable adhesive. Observe the instructions
provided by the adhesive manufacturer.
➤ Mount one clip (fig. 9).
➤ Mount the hood (fig. 9).
6.6

Routing supply lines to condenser unit

I
NOTE
• The installation manual for the SPX1200C condenser unit should also be
observed.
• Mount the SPX1200C condenser unit first to enable the exact position of
the condenser unit to be determined. This will save you bending the cop-
per pipe several times to make it fit.
• Make sure that the maximum length of the supply lines does not exceed
2.1 m.
• Avoid any narrow radiuses when routing and bending supply lines. Use a
suitable round object with a shim as a bending aid. A radius which is too
narrow will kink the refrigerant line, and this will prevent the parking cooler
from operating.
• If you wish to avoid damaging the cab's rear panel, you can also fix the clip
in place using a suitable adhesive. Observe the instructions provided by the
adhesive manufacturer.
➤ Shorten any supply line which is not needed by bending a curve.
➤ Fasten the supply lines to the cab's rear panel using the clips (fig. 0).
6.7

Connecting condenser unit to evaporator unit

➤ Route the connection cable in a curve out through the opening in the floor of
the condenser unit.
➤ Fasten the connection cable as shown (fig. a and fig. b).
EN
Installation
11