Using The Device; Handling Electrical Cables - Dometic Waeco CoolAir RT880 Notice De Montage

Safety instructions
2.1

Using the device

 The freedom of movement of semi-trailers (of the outer edges of the
semi-trailer when turning or jackknifing) and other vehicle attachments
must not be restricted.
 Only use the air conditioning roof unit for the purpose specified by the
manufacturer and do not make any alterations or structural changes
to the device.
 Do not use the air conditioning roof unit if it is visibly damaged.
 The air conditioning roof unit must be installed safely so that it cannot
tip over or fall down.
 Installation, maintenance and repair work may only be carried out by
qualified personnel from a specialist company who are familiar with
the risks involved and the relevant regulations.
 Do not use the air conditioning roof unit near flammable fluids and
gases.
 Do not operate the air conditioning roof unit if the ambient temperature
is below 0 °C.
 Do not undo the upper cover of the air conditioning roof unit in the
event of a fire. Use approved extinguishing agents instead. Do not use
water to extinguish fires.
 Please inquire from your vehicle manufacturer whether the height
entered in your vehicle documentation needs to be altered due to the
installation of the air conditioning roof unit (height 180 mm).
 Disconnect all power supply lines when working on the air conditioning
roof unit (cleaning, maintenance, etc).
2.2

Handling electrical cables

 Use cable ducts to lay cables through walls with sharp edges.
 Do not lay loose or bent cables next to electrically conductive materi-
als (metal).
 Do not pull on the cables.
 Attach and lay the cables in such a manner that they cannot be tripped
over or damaged.
 The electrical power supply may only be connected by a specialist
workshop.
 Fit a fuse of 25 amps to the connection to the vehicle's power supply.
 Never lay power supply lines (battery leads) in the vicinity of signal or
control cables.
28
CoolAir RT880
EN