Starting The Generator; Stopping The Generator - Dometic TEC40D Notice D'utilisation

Operating the generator
8.2 Switching the generator to standby or no function
The generator can be switched to standby or no function with the main switch
(fig. 2 1, page 3) in the connection box.
8.3 Switching the control panel on and off
This switch on the control panel (fig. 3 2, page 4) is for switching the control
panel on and off.
➤ Switch the control panel on with the on/off switch.
✓ The display shows:
The display switches off automatically after 5 minutes if the start button is
not touched within this time.
Press the start button to switch on the display again.
✓ The generator can now be started.
8.4

Starting the generator

The generator can only be started if it is in standby and the control panel is
switched on.
I
NOTE
If the generator is still warm, press the start button briefly to start
it; press longer for a cold generator.
➤ Start up the generator with the green button "START/STOP (fig. 3 3,
page 4).
8.5

Stopping the generator

➤ Stop the generator with the on/off switch (fig. 3 2, page 3).
If the generator does not stop: switch it off with the main switch (fig. 2 1,
page 3).
16
.
GEN OFF
TEC40D
EN