Dometic TEC40D Notice D'utilisation page 25

TEC40D
Check and change the fuel filter as follows (fig. 8, page 6):
➤ Remove the fixing cap (1) and the filter cover (2).
➤ Remove the knurled nut (3).
➤ Take out the air filter (4).
➤ Check the condition of the air filter (4) carefully:
Shine light into the air filter with a lamp and verify if the paper membrane
is damaged.
Replace the air filter:
– if damaged
– if soiled by humid or oily obstruction
➤ Clean the undamaged air filter of dry obstruction.
Clean the filter cartridge with dry compressed air (do not use jets of
compressed air with a pressure of more than 2 – 2.5 bar): Blow the air
from the inside towards the outside, until all the dust has been com-
pletely expelled.
➤ Clean the filter cover (2).
➤ Insert the air filter (4).
➤ Fasten the knurled nut (3).
➤ Mount the filter cover (2).
➤ Fasten the filter cover (2) with the fixing cap (1).
EN
Servicing the generator
25