Troubleshooting - Dometic TEC40D Notice D'utilisation

Troubleshooting

11 Troubleshooting
Fault Cause
The control panel Starter battery is flat.
does not come
Power cable is disconnected or the
on when the
plug is removed.
on/off switch is
pressed.
Fuse (if present) is triggered.
The starter does Starter battery is flat.
not work when
The main switch is at "0".
the start button is
pressed.
Circuit board is damaged.
Starter is not receiving any power.
The starter turns Fuel injector is dirty.
but the genera-
Engine is defective.
tor does not start.
The generator Too much oil in the engine.
tends to go off.
Load is too high.
Air intake is blocked.
Inverter is damaged.
Fault in the injection pump power
supply.
Fuel injector is dirty.
The generator is Inverter is damaged.
running but does
not supply any
The electrical connections are not
voltage.
connected properly.
26
Remedy
➤ Charge the starter battery.
➤ Contact an authorised
workshop.
➤ Charge the starter battery.
➤ Set the main switch to "I" or
"1".
➤ Contact an authorised
workshop.
➤ Contact an authorised
workshop.
➤ Drain the oil (see chapter
"Changing the oil" on
page 23).
➤ Reduce the consumers.
➤ Check the air filter (see chap-
ter "Servicing the air filter" on
page 24).
➤ Contact an authorised
workshop.
➤ Contact an authorised
workshop.
➤ Check the electric
connections.
TEC40D
EN