Troubleshooting - Dometic TEC Série Notice D'utilisation

Troubleshooting

11 Troubleshooting
Fault Cause
The control panel Starter battery is flat.
does not come on
Power cable is disconnected or the plug
when the on/off
is removed.
switch is pressed.
The fuse (if available) is blown.
The starter does Starter battery is flat.
not work when the
The main switch is at "0".
start button is
pressed.
Internal board is damaged.
Starter is not receiving any power.
The starter turns TEC60:
but the generator No petrol.
does not start.
TEC60LPG:
No liquid gas.
Too much oil in the engine.
Spark plug is not receiving any power.
Only TEC60:
Carburettor is not receiving any petrol.
Air intake is blocked.
Inverter is damaged.
Power cable is disconnected or the plug
is removed.
26
TEC60, TEC60LPG
Remedy
➤ Charge the starter battery.
➤ Contact an authorised workshop.
➤ Charge the starter battery.
➤ Set the main switch to "I" or "1".
➤ Contact an authorised workshop.
➤ Fill up with petrol.
➤ Replace the liquid gas bottle.
➤ Drain the oil.
➤ Check the electric connections.
➤ Clean the carburettor.
➤ Check the air filter (see chapter
"Servicing the air filter" on
page 24).
➤ Contact an authorised workshop.
EN