Dometic TEC Série Notice D'utilisation page 27

TEC60, TEC60LPG
Fault Cause
The generator Too much oil in the engine.
tends to go off.
Load is over 6,2 kW.
Only TEC60:
Carburettor is not receiving any petrol.
Air intake is blocked.
Inverter is damaged.
Electromagnet (inverter) is blocked.
Air filter is dirty.
The generator is Inverter is damaged.
running but does
RPM too low.
not supply any volt-
age.
The generator The stepper motor is faulty or the cable is
starts up very fast disconnected.
and then the
"GENERATOR
ALERT" message
appears.
The generated Inverter is damaged.
voltage is unstable.
EN
Troubleshooting
Remedy
➤ Drain the oil.
➤ Switch off the consumers.
➤ Clean the carburettor.
➤ Check the air filter (see chapter
"Servicing the air filter" on
page 24).
➤ Contact an authorised workshop.
➤ Check the output wiring connec-
tion
➤ Contact an authorised workshop.
➤ Contact an authorised workshop.
➤ Contact an authorised workshop.
27